Abstract

This specification covers general requirements that shall apply to stainless wire and wire rods. Wire is intended primarily for cold forming, including coiling, stranding, weaving, heading and machining as covered under the required specifications. The material may be furnished in one of the conditions detailed in the applicable material specification, that is, annealed, bright annealed, or cold worked. Intergranular corrosion test, grain size test, tension test, and chemical analysis shall conform to the chemical and mechanical requirements of the material specification.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers general requirements that shall apply to stainless wire and wire rods. Wire rods are a semifinished product intended primarily for the manufacture of wire. Wire is intended primarily for cold forming, including coiling, stranding, weaving, heading and machining as covered under the latest revision of each of the following ASTM specifications: A 313/A 313M , A 368 , A 478 , A 492 , A 493 , A 580/A 580M and A 581/A 581M .

1.2 In case of conflicting requirements, the individual material specification and this general requirement specification shall prevail in the order named.

1.3 General requirements for flat products other than wire are covered in Specification A 480/A 480M .

1.4 General requirements for bar and billet products are covered in Specification A 484/A 484M .

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6 Unless the order specifies the applicable metric specification designation, the material shall be furnished in the inch-pound units.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A262 Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels

A313/A313M Specification for Stainless Steel Spring Wire

A368 Specification for Stainless Steel Wire Strand

A370 Test Methods and Definitions for Mechanical Testing of Steel Products

A478 Specification for Chromium-Nickel Stainless Steel Weaving and Knitting Wire

A480/A480M Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip

A484/A484M Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings

A492 Specification for Stainless Steel Rope Wire

A493 Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging

A580/A580M Specification for Stainless Steel Wire

A581/A581M Specification for Free-Machining Stainless Steel Wire and Wire Rods

A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment

A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products

E112 Test Methods for Determining Average Grain Size

Federal Standard

Military Standards

Other Standard

Keywords

general delivery requirements; stainless steel wire; stainless steel wire rods; General delivery requirements--steel; Stainless steel wire--specifications; Steel wire--specifications; Steel wire rod--specifications;

ICS Code

ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)

DOI: 10.1520/A0555_A0555M-05R09

ASTM International is a member of CrossRef.

ASTM A555 / A555M