Translated Standard: Spanish
more info

Abstract

This specification covers black and hot-dipped galvanized hot-formed welded and seamless carbon steel square, round, rectangular, or special shape structural tubing for welded, riveted, or bolted construction or bridges and buildings, and for general structural purposes. Special shape and dimensions of tubing are permitted to be furnished provided that such tubing comply with all other requirements of this specification. Test specimens shall be in accordance with other ASTM documents enlisted herein. The tubing shall be manufactured either by seamless, furnace-butt welding (continuous welding), electric-resistance welding or submerged arc welding. Testing of the sample specimens shall include one tension test from a length of each of the tubing representing each lot. If any lot fails the mechanical test, it shall be rejected or retested using additional tubing of double the original number from the lot. The lot shall be acceptable if the results of all such retests conform to the specified requirements.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers black and hot-dipped galvanized hot-formed welded and seamless carbon steel square, round, rectangular, or special shape structural tubing for welded, riveted, or bolted construction of bridges and buildings, and for general structural purposes.

1.2 Square and rectangular tubing is furnished in sizes 1 to 32 in. (25.4 to 813 mm) across flat sides with wall thicknesses 0.095 to 3.00 in. (2.41 to 76 mm), dependent upon size; round tubing is furnished in NPS 1/2 to NPS 24 (see Note 1) inclusive, with nominal (average) wall thicknesses 0.109 to 1.000 in. (2.77 to 25.40 mm), dependent upon size. Special shape tubing and tubing with other dimensions is permitted to be furnished, provided that such tubing complies with all other requirements of this specification.

Note 1The dimensionless designator NPS (nominal pipe size) has been substituted in this standard for such traditional terms as 'nominal diameter,' 'size,' and 'nominal size.'

1.3 This specification covers the following grades:

1.3.1 Grade A36000 psi (250 MPa) min yield strength.

1.3.2 Grade B50000 psi (345 MPa) min yield strength.

1.4 An optional supplementary requirement is provided for Grade B and, when desired, shall be so stated on the order.

1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.7 The text of this specification contains notes and footnotes that provide explanatory material. Such notes and footnotes, excluding those in tables and figures, do not contain any mandatory requirements.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A53/A53M Specification for Pipe, Steel, Black and Hot-Dipped, Zinc-Coated, Welded and Seamless

A370 Test Methods and Definitions for Mechanical Testing of Steel Products

A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment

A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products

A941 Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys

AIAG Standard

Keywords

steel tube; structural steel tubing;

ICS Code

ICS Number Code 23.040.10 (Iron and steel pipes); 23.040.40 (Metal fittings)

DOI: 10.1520/A0501-07

ASTM International is a member of CrossRef.

ASTM A501