ASTM A1044/A1044M-05
Historical Standard: ASTM A1044/A1044M-05 Standard Specification for Steel Stud Assemblies for Shear Reinforcement of Concrete
SUPERSEDED (see Active link, below)
ASTM A1044 / A1044M
1. Scope
1.1 This specification covers steel stud assemblies for shear reinforcement of concrete. Stud assemblies consist of either single-headed studs attached to a steel base rail by welding, or double-headed studs mechanically crimped into a steel shape.
Note 1&38212;The configuration of the studs for stud assemblies is much different than the configuration of the headed-type studs prescribed in Section 7, Figure 7.1 of AWS D1.1/D1.1M. Ratios of the cross-sectional areas of the head-to-shank of the AWS D1.1/D1.1M studs range from about 2.5 to 4. In contrast, this specification requires the area of the head of the studs for stud assemblies to be at least 10 times the area of the shank. Thus, the standard headed-type studs in Section 7, Figure 7.1 of AWS D1.1/D1.1M do not conform to the requirements of this specification for use as stud assemblies for shear reinforcement.
1.2 This specification is applicable for orders in either inch-pound units or in SI units.
1.3 The values stated either in inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
AWS Standard
AWSD1.1/D1.1M-2004 Structural Welding Code--Steel Available from The American Welding Society (AWS), 550 NW LeJeune Rd., Miami, FL 33126.U.S. Military Standards
MIL-STD-163 Steel Mill Products Preparation for Shipment and StorageU.S. Federal Standard
Fed.Std.No.123 Marking for Shipment (Civil Agencies)ASTM Standards
A29/A29M Specification for Steel Bars, Carbon and Alloy, Hot-Wrought, General Requirements for
A36/A36M Specification for Carbon Structural Steel
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
Keywords
base rail; concrete reinforcement; headed studs; shear reinforcement; steel; stud assemblies; Concrete reinforcement--specifications; Shear testing--concrete; Steel; Steel studs;
ICS Code
ICS Number Code 91.080.40 (Concrete structures)
DOI: 10.1520/A1044_A1044M-05
ASTM International is a member of CrossRef.
