eLibrary >
BS ISO 11119-2:2020+A1:2023 Gas cylinders. Design, construction and testing of refillable composite gas cylinders and tubes - Fully wrapped fibre reinforced composite gas cylinders and tubes up to 450 l with load-sharing metal liners >
Expand All
TOC Search:
BS ISO 11119-2:2020+A1:2023 Gas cylinders. Design, construction and testing of refillable composite gas cylinders and tubes - Fully wrapped fibre reinforced composite gas cylinders and tubes up to 450 l with load-sharing metal liners, 2023
- undefined
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Symbols
- 5 Inspection and testing
- 6 Materials
- 6.1 Liner materials
- 6.2 Composite materials
- 7 Design and manufacture
- 7.1 General
- 7.2 Design submission
- 7.3 Manufacturing
- 8 Type approval procedure
- 8.1 General requirements
- 8.2 Prototype tests
- 8.3 New design
- 8.4 Design variants
- 8.5 Type approval test procedures and criteria
- 8.5.1 Proof pressure test
- 8.5.2 Hydraulic volumetric expansion test
- 8.5.3 Liner burst test
- 8.5.4 Cylinder burst test
- 8.5.5 Ambient cycle test
- 8.5.6 Environmental cycle test
- 8.5.7 Flaw test
- 8.5.8 Drop/impact test
- 8.5.9 High velocity impact (gunfire) test
- 8.5.10 Fire resistance test
- 8.5.11 Salt water immersion test
- 8.5.12 Torque test
- 8.5.13 Environmentally assisted stress rupture test
- 8.5.14 Resin shear strength
- 8.5.15 Glass transition temperature
- 8.6 Failure of type approval tests
- 9 Batch inspection and testing
- 9.1 Liner
- 9.2 Failure of liner batch tests
- 9.3 Overwrap materials
- 9.4 Composite cylinder
- 9.5 Cylinder failure during type approval or batch testing
- 10 Cylinder marking
- 10.1 General
- 10.2 Additional marking
- Annex A (informative) Examples of design approval certificate
- Annex B (informative) Specimen test reports
- Annex C (informative) Test report for equivalency
- Annex D (informative) Standardized test requirements for thermally activated pressure relief devices
- Bibliography [Go to Page]