eLibrary >
BS EN ISO 13385-1:2019 Geometrical product specifications (GPS). Dimensional measuring equipment - Design and metrological characteristics of callipers >
Expand All
TOC Search:
BS EN ISO 13385-1:2019 Geometrical product specifications (GPS). Dimensional measuring equipment - Design and metrological characteristics of callipers, 2019
- National foreword
- European foreword
- Endorsement notice
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Design characteristics
- 4.1 General design and nomenclature
- 4.2 Dimensions
- 5 Metrological characteristics
- 5.1 General
- 5.2 Rated operating conditions
- 5.3 Reference point
- 5.4 Test methods
- 5.5 Partial surface contact error, E (limited by EMPE)
- 5.6 Shift error, S (limited by SMPE)
- 5.6.1 General
- 5.6.2 Shift error — Internal measuring faces
- 5.6.3 Shift error — Crossed knife-edge internal measuring faces
- 5.6.4 Shift error — Depth or step measuring faces
- 5.7 MPE values
- 5.8 Special cases
- 6 Determination of conformity to specifications
- 6.1 General
- 6.2 Measurement uncertainty
- 6.3 Decision rule
- 7 Marking
- Annex A (informative) Calibration guidelines for metrological characteristics
- Annex B (normative) Default MPE values for metrological characteristics
- Annex C (informative) Relation to the GPS matrix model
- Bibliography [Go to Page]
