eLibrary >
BS EN 88-2:2022+A1:2024 Safety and control devices for gas burners and gas burning appliances - Pressure regulators for inlet pressures above 50 kPa up to and including 500 kPa >
Expand All
TOC Search:
BS EN 88-2:2022+A1:2024 Safety and control devices for gas burners and gas burning appliances - Pressure regulators for inlet pressures above 50 kPa up to and including 500 kPa, 2024
- undefined
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Classification [Go to Page]
- 5 Test conditions and uncertainty of measurements
- 6 Design and construction [Go to Page]
- 7 Performance [Go to Page]
- 8 Electrical requirements [Go to Page]
- 9 Electromagnetic compatibility (EMC) [Go to Page]
- 10 Marking, instructions [Go to Page]
- Annex A (informative)Abbreviations and Symbols
- Annex B (informative)Leak-tightness tests for gas controls – volumetric method
- Annex C (informative)Leak-tightness tests for gas controls – pressure loss method
- Annex D (normative)Conversion of pressure loss into leakage rate
- Annex E (normative)Electrical/electronic component fault modes
- Annex F (normative)Additional requirements for safety accessories and pressure accessories as defined in EU Directive 2014/68/EU
- Annex G (normative)Materials for pressurized parts
- Annex H (normative)Additional materials for pressurized parts
- Annex I (normative)Requirements for controls used in DC supplied burners and appliances burning gaseous or liquid fuels
- Annex J (normative)Method for the determination of a Safety Integrity Level (SIL)
- Annex K (normative)Method for the determination of a Performance Level (PL)
- Annex L (informative)Relationship between Safety Integrity Level (SIL) and Performance Level (PL)
- Annex M (normative)Reset functions
- Annex N (informative)Guidance document on Environmental Aspects
- Annex O (normative)Seals of elastomer, cork and synthetic fibre mixtures
- Annex AA (informative)Typical pressure regulators and safety devices [Go to Page]
- Annex BB (informative)Overview of requirements and test conditions (as given in 7.101), and examples of performance curves for pressure regulators
- Annex CC (normative)Creep relief device [Go to Page]
- Annex DD (informative)Comparison between EN 334:2019 and !EN 88-2:2022+A1:2024"
- Annex ZA (informative)Relationship between this European Standard and the essential requirements of Regulation (EU) 2016/426 aimed to be covered [Go to Page]
