eLibrary >
BS EN 15619:2014 Rubber or plastic coated fabrics. Safety of temporary structures (tents). Specification for coated fabrics intended for tents and related structures >
Expand All
TOC Search:
BS EN 15619:2014 Rubber or plastic coated fabrics. Safety of temporary structures (tents). Specification for coated fabrics intended for tents and related structures, 2014
- Contents Page
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 General description of coated fabrics intended for tents
- Figure 1 — Schema of a cross section of a woven fabric coated on both sides
- 5 Characteristics relating to coated fabrics [Go to Page]
- 6 Requirements
- Table 1 — Tensile strength requirements for coated fabrics intended for tents and related structures
- Table 2 — Tear strength requirements for coated fabrics intended for tents and related structures
- Table 3 — Coating adhesion requirements for coated fabrics intended for tents and related structures
- Table 4 — Elongation requirements for coated fabrics intended for tents and related structures
- Table 5 —Residual deformation requirements for coated fabrics intended for tents and related structures
- Table 6 — Colour fastness requirements for coated fabrics intended for tents and related structures
- Table 7 — Microorganism development requirements for coated fabrics intended for tents and related structures
- Table 8 — Optional properties - Elongation under load after heat exposure
- Table 9 — Optional properties - Residual deformation after heat exposure and load
- Table 10 — Optional properties – Water penetration
- 7 Information provided by the coated fabric producer
- Annex A (normative) Artificial ageing by long term exposure to the combination of UV irradiation, elevated temperature and water
- A.1 General
- A.2 Exposition programme
- A.3 UV cycle
- A.4 Moisture cycle
- A.5 Preparation of specimens
- A.6 Procedure
- A.7 Measurements after ageing
- A.8 Test report
- Annex B (normative) Coating adhesion
- B.1 General
- B.2 Preparation of the test specimens
- B.3 Welding
- B.4 Testing
- Figure B.1 — Coating adhesion – main steps of the testing preparation
- B.5 Test report
- Annex C (informative) Weld resistance recommendation
- C.1 General
- C.2 Weld resistance
- Table C.1 — Weld resistance recommendation
- C.3 Preparation of test specimens and test procedure
- Figure C.1 — Welding resistance
- C.4 Test report
- Annex D (informative) Assessment of conformity
- D.1 General
- D.2 Type tests
- D.2.1 Initial type tests
- D.2.2 Supplementary type tests
- D.3 Factory production control
- D.3.1 General
- D.3.2 Control of the raw materials
- D.3.3 Control of the procedure
- D.3.4 Calibration plan
- D.4 Testing of the finished products
- D.4.1 Direct testing
- D.4.2 Indirect evaluation
- D.5 Inspection and testing
- D.6 Traceability
- D.7 Marking
- Bibliography [Go to Page]