eLibrary >
BS EN 16434:2014 Internal blinds. Protection from strangulation hazards. Requirements and test methods for safety devices >
Expand All
TOC Search:
BS EN 16434:2014 Internal blinds. Protection from strangulation hazards. Requirements and test methods for safety devices, 2014
- Foreword
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 General
- 5 Artificial ageing [Go to Page]
- 6 Tensioning device [Go to Page]
- Figure 1 — Principle of the test of tensioning device [Go to Page]
- Figure 2 — Measurement of the distance between the two strands [Go to Page]
- 7 Breakaway device [Go to Page]
- Figure 3 — Illustration of the test of a breakaway device on a looped cord
- Figure 4 — Illustration of the test of a breakaway device on hanging pull cords connected together
- Figure 5 — Illustration of the test of a breakaway device on an inner cord [Go to Page]
- 8 Accumulation device [Go to Page]
- 9 Non tangling device [Go to Page]
- Figure 6 — Illustration of the test of a non tangling device [Go to Page]
- 10 Inner cord stop [Go to Page]
- Figure 7 — Illustration of the inner cord stop test [Go to Page]
- 11 Additional requirements [Go to Page]
- Figure 8 — Small part cylinder [Go to Page]
- 12 Information and instruction for installation, use and maintenance [Go to Page]
- 13 Factory Production Control (FPC)
- Annex A (informative) Tests to be carried out on safety devices
- Table A.1—Test samples to be tested depending on artificial ageing conditions
- Bibliography [Go to Page]