|
FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of PD ISO/TR 27609:2007 2007This Technical Report presents an evaluation of a round-robin test of vibration measurement methods for determining vibration in hand-held grinders. The aim of the round-robin test was to establish a test method that could meet the requirement of ISO 20643 for measurement of vibration emissions in three directions, for accordance with the planned-to-be-revised ISO 8662-4. The value obtained by such a test method must correspond to the highest vibration values likely to occur under typical and normal working conditions of the machine, i.e. the upper quartile of the vibration in real use. This acknowledges that the upper boundary of “typical and normal” conditions can be exceeded by some conditions of “real use”. Vibration at grinding can mainly be divided into vibration caused by unbalance of the grinding wheel and process vibration generated by the contact between the grinding wheel and the work piece. The unbalance part has been shown to be the greater of the two and ISO 8662-4 is based on this. In this Technical Report, the test method consists of a number of averaged measurements using an unbalance disc, with an unbalance corresponding to the upper limit of the unbalances found among real grinding wheels. Whereas ISO 8662-4 covers all types of hand-held grinders, the round-robin test presented in this Technical Report was based on grinding with depressed centre-wheels, one of the most common grinding applications. The types of grinder used in the round-robin test are given in Table 1. Table 1 Grinder types and sizes used in test
Two tests of the grinders were made: one using an unbalance disc and the other by real grinding. The unbalance disc test was made with a disc of new design, with the shape of a depressed centre wheel. One reference disc was sent together with the grinding machines, while the other was locally manufactured by the measuring lab. Grinding was made on mild steel with locally purchased grinding wheels. Detailed test instructions were distributed to the participants before the start of the round-robin test.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|