FORMAT
BOOKS
PACKAGES
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS 1722-1:2019 2019This part of BS 1722 specifies requirements for chain link fences and gates and gateposts for use with chain link fences. The gates specified are steel with a provision for chain link infill or other infill if required by the client. This British Standard specifies requirements for fences up to 3.60 m in height with a chain link mesh infill. For other security fences, refer to BS 1722‑10, BS 1722‑12 and BS 1722‑14, and for chain link mesh specifications refer to BS EN 10223‑6. This British Standard is divided into requirements for the material components for fences and for installation of the fences. This standard also specifies requirements for protective treatments. However, maintenance requirements for the fence after installation are outside the scope of this standard. This British Standard specifies requirements for sizes of components. These are minimum requirements, and it is acceptable to use larger sizes, except where this could adversely affect the fitting of components, or if replacement parts are required to match with those already present. Ground conditions might indicate that a variation in the length of a post or strut, or the depth to which these can be set, is desirable. The posts and struts and setting depths specified in this part of BS 1722 are intended for use in normal ground conditions, but if special conditions exist that warrant variations in the specification, e.g. the ground is softer or firmer than usual, such a change needs to be agreed with the specifier.
The following editions for this book are also available...
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|