ASTM F1758-05
Historical Standard: ASTM F1758-05 Standard Test Methods for Detention Hinges Used on Detention-Grade Swinging Doors
SUPERSEDED (see Active link, below)
ASTM F1758
1. Scope
1.1 These test methods cover the apparatus, procedures, and acceptance conditions for evaluating the normal operating performance characteristics and the performance characteristics under assault conditions of hinges used in swinging door assemblies in detention and correctional institutions. These types of hinges are described in detail in , , and . Thus, these test methods only give an indication of the performance characteristics of hinges in actual service. Such variables as installation and maintenance conditions which have a potential impact on performance characteristics are not considered.
1.2 It is the intent of these test methods to help ensure that detention hinges (reference to hinges is inclusive of a continuous hinge) perform at or above minimum acceptable levels to confine inmates, to delay and frustrate escape attempts, and to resist vandalism and assault conditions. It is recognized that in order to meet the intent of these test methods, door, frame and lock assemblies must be compatible with the level of performance required by Test Methods F 1450 and F 1577.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.
1.4 Consult NFPA 80 for Fire Doors Windows concerning hinge requirements on fire doors.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
NFPA Standard
NFPA80 Fire Doors and Fire WindowsASTM Standards
F1450 Test Methods for Hollow Metal Swinging Door Assemblies for Detention and Correctional Facilities
F1577 Test Methods for Detention Locks for Swinging Doors
F1592 Test Methods for Detention Hollow Metal Vision Systems
F1643 Test Methods for Detention Sliding Door Locking Device Assembly
F1915 Test Methods for Glazing for Detention Facilities
Keywords
assault condition; correctional facility; detention facility; detention hinges; detention security; normal operation ;
ICS Code
ICS Number Code 91.060.50 (Doors and windows)
DOI: 10.1520/F1758-05
ASTM International is a member of CrossRef.
