Abstract
This specification covers standards for silicomanganese of Grades A, B, and C. Materials shall conform to manganese, silicon, carbon, phosphorus, and sulfur contents, as well as supplemental requirements of arsenic, tin, lead, chromium, nickel, and molybdenum. The material shall also conform to standard sizes and tolerances.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers grades of silicomanganese.
1.2 Units The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.2.1 This specification is expressed in both inch-pound units and in SI units (within the text, the SI units are shown in brackets); however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A1025 Specification for Ferroalloys and Other Alloying Materials, General Requirements
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
Keywords
Manganese alloying additives--specifications; Silicomanganese; Stainless steel alloying additives (manganese);
ICS Code
ICS Number Code 77.100 (Ferroalloys)
DOI: 10.1520/A0483_A0483M-10
ASTM International is a member of CrossRef.
ASTM A483 / A483M